Start-Up Request Form | Lighting Partners of Central Florida

Step 1 of 5

20%

Job Name:

Today's Date(Required)

MM slash DD slash YYYY

Address

Street Address City State / Province / Region

Job PO #:

Electrical Contractor:

Project Manager Name:

Project Manager #:

Project Manager Email:

Site Contact Name:

Site Contract #:

Site Contact Email:

Requested Start-up Commissioning Date:

MM slash DD slash YYYY

General

All panels, room controllers, switches, occupancy sensors, photocells, and other peripheral devices have been terminated and are powered.
All RJ-45 CAT5/5E cables have been terminated and properly tested.
All as-built documentation is complete, accurate and submitted to Lighting Partners at least 2 weeks prior to the commissioning start-up date.
The as-built information must include the following.
- Panel/Room load schedules
- Switch schedules
- Occupancy sensor settings. Auto On/Off, Vacancy Only and time out
- Daylight harvesting information
- Time clock schedules
- Any programming information that may be required for a fully functioning system.
An electrician familiar with the installation of the lighting control system, must be available with ladders or anything else for access to the system components.
Ensure that end user representatives are to be onsite for orientation and training on the system.

Daylighting Systems

All daylighting sensors have been installed and fully operable.
The daylighting control areas are completed and ready for occupancy.

Dimming Systems

All dimming controllers have been terminated and are powered.
All lighting fixtures have been installed and 0-10V dimming wires have been installed and verified.

Have questions?? Give us a call (407) 852-7171

Please confirm all of the following tasks are complete:(Required)

Line Voltage terminated and verified

Line/Loads terminated to the relays/dimmers

Lighting loads with 0-10v dimming wiring has been tested for proper polarity

Control devices terminated to the controller and ready to be tested

All communication cable properly installed, tested, and terminated

Updated panel schedules or As-built information completed and sent into Lighting Partners controls department. Email controls@lightingpartnerscf.com

Times schedule information sent into Lighting Partners

Interfacing with a Building Management System.

BMS Company:

Contact Name:

Contact #:

Start-up and training have been coordinated with the following parties:(Required)

General Contractor

Maintenance Staff

Building Owner

End User

Will training happen during the visit.(Required)

Yes

Requested Training Date

MM slash DD slash YYYY

Requested Training Time

Hours

Minutes

AM/PM

NOTE: An additional charge may apply if training is not scheduled during the time of the start-up.

Additional Information

Is there anything else we should know?

Please read & sign

If the items are not completed, as verified above, on the arrival of the Field Engineer, then the Field Engineer will leave the job site and the contractor or distributor will be charged the full cost of the scheduled visit. Another visit will need to be rescheduled with Lighting Partners at the contractor/distributor’s expense once all the above items have been completed.

Signature